Troubleshooting guide
Synology Tailscale Access: Test from Cellular, Not Home Wi-Fi
Category: Remote Access
synology tailscale not working.
A Synology share that works on home Wi-Fi can still fail remotely because the client is using a LAN address, Tailscale is offline, or the share permissions are wrong.
Before you start
- Synology NAS with Tailscale installed
- One phone or laptop with Tailscale
- A test share and a small readable file
- Mobile data available
Step-by-step checks
Step 1: Verify both Tailscale nodes
Open the Tailscale admin/client view and confirm the NAS and remote device are online in the same tailnet. Check key expiry and the last-seen time.
Check: Both devices show connected and are not key-expired.
Step 2: Use the Tailscale address
Find the NAS Tailscale IP or MagicDNS name. Replace the old 192.168.x.x address in the client with the Tailscale address.
Check: The client is configured with the Tailscale address, not the LAN IP.
Step 3: Switch to cellular
Turn off Wi-Fi on the phone, wait for mobile data, and confirm Tailscale remains connected. Open the NAS URL or app from the Tailscale address.
Check: The client reaches the Synology login over cellular.
Step 4: Open a named share and file
Sign in with the test account, open one specific share, and read a small file. Confirm the content and that no other share was used as a fallback.
Check: The named file opens from the remote client.
Step 5: Restart and repeat
Restart the Tailscale client, reconnect on cellular, and open the same file again. Note whether the NAS Tailscale service starts automatically after a reboot.
Check: Access survives a client restart.
Verify the result
With Wi-Fi off, the client reaches the NAS over Tailscale, opens the named share, and reads the test file after a client restart.
Rollback
Remove the test client from Tailscale or sign it out after verification. Leave existing shares and accounts unchanged.
Ask for help with this exact symptom · All troubleshooting guides