Troubleshooting guide
Tailscale Synology Package Update: Fix Connection Timeouts After Updating
Category: Remote Access
tailscale synology package update. You updated the Tailscale package on your Synology NAS, and now the package shows connected but every remote request times out.
Confirm the package and tunnel state
Open Package Center and check whether Tailscale is running. Then open the Tailscale admin console and confirm the NAS appears online. If the console shows the NAS as connected but the status is stale, the tunnel may be up while the local service is not passing traffic. On the NAS, open a terminal and run tailscale status. A healthy result lists the NAS and peers with direct or relayed connections. If it hangs or returns no peers, the daemon is not fully initialized after the update.
Restart the package cleanly
Stop Tailscale in Package Center, wait ten seconds, then start it again. This forces the updated package to reload its configuration. After it starts, run tailscale status again. If peers appear but requests still time out, run tailscale ping <peer-name> from the NAS. A reply confirms the tunnel works; a timeout points to a routing or firewall rule changed by the update.
Check the update’s firewall and route changes
Review Control Panel > Security > Firewall. The update may have added or reordered rules. Ensure the Tailscale interface is allowed and that no rule blocks established traffic. Also confirm the NAS still advertises the same subnet routes or exit node settings in the admin console. If routes were reset, re-approve them.
Verification test
From a remote device on Tailscale, ping the NAS’s Tailscale IP, then open a shared folder or the DSM login page. A successful ping with a working DSM page confirms recovery. If ping succeeds but DSM times out, the issue is the DSM service, not the tunnel.
Rollback note
If timeouts persist, reinstall the previous Tailscale package version from Package Center’s manual install option, then restart. Keep the current configuration backup before rolling back.
If these steps do not restore access,
