Troubleshooting guide
Tailscale Synology Connection Timeout After an Update
Category: Remote Access
You updated the Tailscale package on your Synology NAS, and now the package says connected while every remote request times out.
Confirm the timeout is not a stale session
Open Tailscale on the NAS and note the status. Then from a remote device, run tailscale ping <nas-name>. If it returns no reply or times out, the control plane is reachable but the data path is not. Next, run tailscale status on the NAS; look for the NAS peer showing direct or relayed. If it shows relayed but requests still time out, the issue is likely local routing or the package’s network hooks after the update.
Check the package and network state
In Package Center, confirm the installed Tailscale version and whether it reports running. Stop and start the package once; this reapplies its network configuration. Then verify the NAS still has a valid Tailscale IP with tailscale ip -4. If the IP is missing or changed, the update may have reset the node identity. Also check that Synology’s firewall still permits the Tailscale interface; an update can reorder rules. If the firewall shows a deny for the tailscale0 interface, re-allow it.
Verification test
From the remote device, ping the NAS Tailscale IP directly, then open one shared folder over the Tailscale address. If the ping succeeds and the share opens, the tailscale synology connection timeout is resolved. If ping succeeds but the share times out, the problem is service-level, not the tunnel.
Rollback and recovery
If the timeout began immediately after the update, reinstall the previous Tailscale package version from Synology’s package archive, then restart the package. Keep a note of the working version before updating again.
If these checks do not restore access,

Ask for help with your tailscale status output and package version.