Troubleshooting guide

Tailscale Exit Node on Synology: Fix Mobile Data and Exit Node Failures

Category: Remote Access

You’re trying to reach your Synology NAS remotely, but when your phone switches to mobile data or you enable an exit node, the connection drops and you can’t complete a controlled diagnosis.

Check IP Forwarding on the Synology

SSH into the NAS and run:

sysctl net.ipv4.ip_forward

If it returns 0, forwarding is off. Enable it with sudo sysctl -w net.ipv4.ip_forward=1 and make it persistent by adding net.ipv4.ip_forward=1 to /etc/sysctl.conf. Without this, the tailscale exit node synology setup cannot route traffic.

Verify Exit Node Advertise and Approval

On the NAS, run tailscale status and confirm the exit node shows offers exit node. In the Tailscale admin console, go to Machines, select your Synology, and ensure “Use as exit node” is approved. If it’s pending, approve it and wait 30 seconds.

Test the Mobile Data Path

Disable Wi-Fi on your phone, enable mobile data, and open the Tailscale app. Toggle the exit node on. Run tailscale ping <NAS-Tailscale-IP> from another device on your tailnet. A successful reply means routing works; a timeout means the exit node isn’t forwarding.

Check ACLs and Firewall

In the admin console, review Access Controls. Ensure your phone’s user has autogroup:internet access when using an exit node. On the Synology, confirm the firewall allows UDP 41641 and the Tailscale interface.

Verification Test

From your phone on mobile data with the exit node active, browse to http://<NAS-Tailscale-IP>:5000. If DSM loads, the path is restored. If not, run tailscale netcheck on the NAS and note any DERP relay issues.

Rollback Note

If changes break local access, disable the exit node in the Tailscale app, revert sysctl changes, and restart the Tailscale package. For guided diagnosis,

A phone on cellular data opening a Synology share through Tailscale

Ask for help.


Back to the service page · Ask about this exact symptom