Troubleshooting guide
Mobile Data and Exit Node Failures: A Step-by-Step Diagnosis for Synology Tailscale
Category: Remote Access
You’re trying to reach your Synology NAS over Tailscale, but when your phone switches to mobile data or you enable an exit node, the connection drops—and you’re stuck before you can even run a proper diagnosis. Let’s walk through it calmly.
Check 1: Confirm Tailscale status on the phone
Open the Tailscale app on your phone. Verify the toggle is on and the status shows Connected. If it says Connecting or No network, toggle it off and on. A stable Connected status means the tunnel is up; if it never connects, the issue is likely the mobile carrier blocking UDP or the app needing a restart.
Check 2: Test the NAS directly by IP
From the phone’s browser, try http://[Tailscale-IP-of-NAS]:5000 (replace with your NAS’s Tailscale IP). If this loads but the hostname doesn’t, DNS is the culprit—switch to using the IP temporarily. If it fails entirely, proceed.
Check 3: Verify exit node routing
If you’re using an exit node, go to Tailscale app > Exit Node and confirm it’s set to the correct node. Then test: disable the exit node and try accessing the NAS again. If it works without the exit node, the exit node itself is misconfigured or unreachable—check that the exit node device is online and has IP forwarding enabled.
Verification test
With mobile data on and exit node disabled, open a browser and load your NAS’s Tailscale IP. A successful login page means the mobile-data path works. Then re-enable the exit node and repeat. If it fails only with the exit node, the problem is isolated to that node.
Rollback and recovery
If changes break access, revert to the last working state: disable the exit node, use the NAS’s Tailscale IP directly, and restart the Tailscale service on both devices. This restores basic connectivity while you investigate further.
For persistent synology tailscale mobile data issues,

Ask for help and we’ll guide you through a deeper diagnosis.