Troubleshooting guide

Synology Remote Access Cellular: Tailscale Shows Connected but SMB/DSM Unreachable

Category: Remote Access

You’re on cellular, Tailscale says connected, but SMB or DSM still won’t open on your Synology NAS.

Confirm the Tailscale IP and port

On the remote device, open Tailscale and note the NAS’s Tailscale IP (100.x.x.x). In a browser, try http://100.x.x.x:5000 (DSM) and smb://100.x.x.x (SMB). If DSM loads but SMB fails, the issue is SMB-specific; if both fail, it’s routing or firewall.

Check the NAS firewall

In DSM, open Control Panel > Security > Firewall. Ensure the Tailscale interface (tailscale0) is allowed, or temporarily disable the firewall and retest. If access returns with the firewall off, add a rule permitting the Tailscale subnet 100.64.0.0/10 on ports 5000/5001 and 445.

Verify SMB service and share permissions

In Control Panel > File Services > SMB, confirm SMB is enabled. Then check Shared Folder permissions for your user. If DSM works but SMB doesn’t, this is the usual culprit.

Test from another Tailscale device

From a second device on the same tailnet, ping the NAS Tailscale IP. A reply confirms the tunnel; no reply points to ACLs or the NAS Tailscale service. This is also a good check for synology remote access cellular reliability.

Verification test

Reconnect cellular, open smb://100.x.x.x and DSM at :5000. Both should load. If only one does, revisit the matching section above.

Rollback note

If a firewall change breaks local LAN access, re-enable the previous rule or disable the new one. Keep a local admin session open while testing.

Still stuck?

A phone on cellular data opening a Synology share through Tailscale

Ask for help.


Back to the service page · Ask about this exact symptom