Troubleshooting guide
Synology Firewall Blocking Tailscale: Diagnose and Restore Remote Access
Category: Remote Access
synology firewall tailscale. You’re connected to Tailscale, but the Synology firewall is silently dropping your remote session, leaving you stuck before you can even run a proper diagnosis.
Confirm the firewall is the cause
First, isolate the firewall. Temporarily disable the Synology firewall (Control Panel > Security > Firewall) and retry your remote connection. If access returns immediately, the firewall is confirmed as the blocker. Re-enable it right away before continuing.
Check the Tailscale interface rule
The firewall must allow traffic on the Tailscale interface (usually tailscale0). In Control Panel > Security > Firewall > Edit Rules, verify there is an allow rule for the tailscale0 interface, or that your custom rules don’t inadvertently deny it. A common mistake is a deny-all rule placed above the Tailscale allow rule; order matters. Move the allow rule above any broad deny.
Verify the source and port
If you use subnet routing or specific services, confirm the rule permits the Tailscale IP range (100.64.0.0/10) and the required ports. For DSM access, port 5000/5001 must be allowed from the Tailscale interface. Check that the rule’s source is set to the Tailscale interface, not “All,” which can conflict with other deny rules.
Verification test
With the corrected rule in place, reconnect via Tailscale. Then, from another Tailscale device, ping the NAS Tailscale IP and attempt to open DSM. A successful ping and login confirm the firewall now passes traffic. If it still fails, re-check rule order and interface selection.
Rollback note
If changes worsen access, re-enable the previous firewall configuration or temporarily disable the firewall to regain local access, then review logs under Log Center for denied packets.
If you’re still stuck after these steps,

Ask for help and we’ll review your specific rule set.